All Aluminum Conductors
(AAC)
Description

Hard drawn Aluminum wires, stranded in successive layers, in opposite direction to form the Aluminum stranded AAC conductor

Application

All Aluminum Conductors(AAC) can be used as a bare overhead conductor for distribution lines. Because of its low strength-to-weight ratio, (AAC) has limited use in transmission lines. AAC is extensively used in urban areas where spans are usually short but high conductivity is required

Relevent Standard
BS EN 50182, BS 215-1, DIN 48201-5, IEC 61089, ASTM B 231
Conductor
Plain bare Hard drawn Aluminum - H14
Minimum bending Radius
25 x outer diameter
Packing Condition
Our standard length on Wooden Drum / or according to customer request

The above values of current carrying capacity are calculated due to frequency up to 60 Hz, assuming an ambient temperature of 35 °C, final temperature of 80 °C, wind velocity of 0.6 m/sec, solar radiation of 900 W/m², emissivity coefficient of 0.6, solar radiation absorption coefficient of 0.5

Product – Code Cross Sectional
Area mm²
Minimum Number of
Wires No X mm
Max. D.C. Conductor
Resistance at 20 °C Ω/km
Approx. Overall
Diameter mm
Minimum Breaking
Load KN
Approx. Weight
kg/km
Rated Current
Amps
ASTM B 231
BS EN 50182 (GREMANY) & DIN 48201-5
IEC 61089
BS 215-1
BS EN 50182 (United Kingdom)

The above data is approximate and subject to manufacturing tolerances